P
reli
mi
na
ry
Network Configuration Window
SANbox-8/16 Switch Management
2-38
SANsurfer Switch Management
59010-06 Rev. A
User’s Manual
cursor to the field and type the new data. Write the contents of this field to the
Switch Flash memory by pressing the Apply Button. The application will ask
whether to Reset the Switch. If no is chosen, the Apply will still write the new
address to Flash but will not Reset the Switch. The Switch will start using the new
Subnet Mask when it is Reset. If yes is chosen, the Switch will Reset and start
using the new Subnet Mask.
Gateway
The Gateway box displays the IP Address of the Gateway (if any) used by the
Switch Management port. The default set at the factory is 0.0.0.0. Modify this
field by moving the cursor to the field and typing. Write the contents of this field
to the Switch Flash memory by pressing the Apply Button. The application will
ask if the Switch is to by reset. If no is chosen, the Apply will still write the new
address to Flash but will not Reset the Switch. The Switch will start using the new
Gateway Address when it is Reset. If yes is chosen to the Reset question, the
Switch will Reset and start using the new Gateway Address.
ARP Timeout
This value is in hundredths of a second (.00). The default set at the factory is
30000 (300.00 seconds). To modify this field, move the cursor to the field and type
the new value.Write the contents of this field to the Switch by pressing the Apply
Button.
Ethernet MAC
The Ethernet MAC field is read-only and displays the MAC Address of the
Switch’s Ethernet port.
SNMP Configuration
Use the SNMP Configuration area of this screen to read, modify, or write the
Switch Management SNMP switch name, contact person, and Switch location.
SNMP Trap Authentication Check Box
Check this box to send a trap to the address in the Trap IP Address field in the
event that an attempt is made to access the Switch with the wrong Community
Names.
NOTE:
If you misconfigure the entry and lose communication with the Switch, the Switch
must be placed in Force PROM mode. This forces the use of the default IP Address,
Subnet Mask and Gateway Address. Then go back to the Configuring the Switch
Ethernet Port paragraphs near the beginning of this section and start over. Contact
QLogic Customer Support for information about how to place the Switch in Force
PROM Mode.
Summary of Contents for SANbox-8
