4
©2005 QLogic Corporation. QLogic, SANbox, and SANsurfer Switch Manager are trademarks or registered trademarks of QLogic Corpo-
ration. All other trademarks are the property of their respective companies. Information supplied by QLogic is believed to be accurate and
reliable. QLogic Corporation assumes no responsibility for any errors in this brochure. QLogic Corporation reserves the right, without notice,
to make changes in product design or specifications.
Step 8. Obtain Network Configuration
❑
Obtain the IP address and subnet mask from your network administrator.
Step 9. Run the Configuration Wizard
❑
Double-click the SANsurfer Switch Manager shortcut, or select
SANsurfer Switch Manager
from Start menu, depending on how you installed SANsurfer Switch Manager.
❑
Connect the switch and the workstation using an Ethernet crossover cable, switch, or hub.
❑
The Configuration Wizard tool will auto-detect and configure the switch based on selected
options and recommended settings. Follow the instructions to set network parameters and
the password.
NOTE:
If you are using an Ethernet switch and the auto-connect process fails due to a time out,
try a direct connection from your workstation to the switch using an Ethernet cross-over cable.
Step 10.Connect Devices and Switches
❑
Connect fibre optic cables between the installed SFP transceivers and their corresponding
devices. Each port auto-negotiates the proper port type with the connected device or switch.
Congratulations!
You have successfully installed your QLogic SANbox 5202
Switch!
For technical support, visit our web site at
support.qlogic.com
, email us at
,
or call us at 952-932-4040. For more detailed installation instructions, see the
SANbox 5200 Series
Fibre Channel Switch Installation Guide
, located on the product CD or on the QLogic web site.
