Qlogic QConvergeConsole CLI 2400 Series, User Manual

Page: 90 / 366

5–Fibre Channel Noninteractive Commands
-l (Display LUN Info)
5-22 SN0054667-00 C
If the read/write buffer test fails, the system shows the following information:
 Loop/port ID (the loop ID of the adapter when operating in loop mode).
 Status :
 Success —The test passed.
 Error —A data miscompare or link status firmware error occurred.
 Failed —A link status error, SCSI write buffer error, or SCSI read buffer
error occurred.
 Unknown —The target was not present.
 Unsupported —The device does not support this test.
 Data Miscompare —The possible values are:
 0 (no data miscompares)
 Device not present
 Get link status failed
 Read buffer failed
 R/W buffer not supported
 Write buffer failed
 Link Failure —Number of link failures
 Loss of sync —Number of sync loss errors
 Loss of signal —Number of signal loss errors
 Invalid CRC —Number of invalid CRCs
-l
(Display LUN Info)
This command shows LUN information for:
 All adapters
 A specific target
 A specific LUN on a specific target
To show the LUN information for all target devices for a specific adapter Instance ,
issue the following command:
# qaucli -pr fc -l (< hba instance > | < hba wwpn >)
To show the LUN information for a specific device for a specific adapter port, issue
the following command:
# qaucli -pr fc -l (< hba instance > | < hba wwpn >) (< target port
id > | < target wwpn >)