QLOCKTWO LARGE, Instructions For Use Manual, Page: 5 / 11

9 8
5. Mounting the QLOCKTWO LARGE
QLOCKTWO LARGE is ready to be hung onto the wall bracket. Before mounting the QLOCKTWO LARGE, hang
the mains adapter (E) with the strain relief in the cable hook and insert the DC-connector (F) into the 18 V
socket (B), see fig. 1, 2, 3.
Make sure there is no cable loop between the wall bracket and the body.
4. Electrical connection
Option 1: Power supply via a direct power outlet from the wall (see fig. 2).
Insert the power plug (G) into the mains adapter (D).
Only trained electricians should connect the
mains adapter (D) to the power outlet in the wall (N) and fit the junction box (L).
Option 2: Power supply via a plug socket (see fig. 3).
Hang the mains adapter (E) with the strain relief (M) on the cable hook.
Insert the DC-connector (F) into the 18 V socket (B). Now, the QLOCKTWO LARGE can be hung on
the wall bracket. Afterwards, the power supply cable
(G) is inserted into a plug socket. The cable
runs through the cable conduit (I) of the wall bracket. You might need an adapter to fit your coun-
try’s type of sockets (see scope of delivery/labelling on the packaging). If you are uncertain, ask a
qualified electrician for advice. Securing
Stand in front of the QLOCKTWO LARGE. Reach
above the QLOCKTWO to the upper side of the wall
bracket (H) and secure the QLOCKTWO as follows:
Mounting rails (K)
Power supply cable loop
QLOCKTWO LARGE
Wall bracket (H)
Wall
1. Lift the lever upwards.
2. Move the lock pin into the designated slot
thus securing the QLOCKTWO LARGE.
TIP
Bring QLOCKTWO LARGE towards the wall
bracket evenly, about 1 cm higher than the
final position. Press lightly against the wall
bracket until the mounting rail engages.
Now QLOCKTWO LARGE can slowly be lowered.
Ensure that all four mounting rails are properly
placed into the counter pieces.
QLOCKTWO LARGE Wall bracket (H)