Qlima SRE7037C-2, Operating Manual

Page: 135 / 228

135
4
THE INFORMATION DISPLAY
The information display

not only serves as an indicator of the (set) time and
temperature (sections C, E, and F), it also indicates any malfunctioning of the
heater. The code on the information display tells you what is the matter:
Code Information Action
Time
----
The heater has been automa-
tically turned off by a power
cut or bad connection.
Restore power or restore the
connection. Press the ON /
OFF key
20 20 again.
E01
An earthquake (magnitude 5
or more), strong vibrations or
a shock will ensure that the
heater automatically
turns off. (The safety system
against shocks has worked).
Make sure there are no com-
bustible materials around the
heater, or fuel leakages. Press
the ON / OFF key
20 20 again.
E02
E03
The heater has been automa-
tically turned off after a fault
or during ignition or due to
the presence of water or dust
in the fuel filter or in the
fixed tank.
Remove the water and the
dust in the fixed tank. Clean
the fuel filter (see chapter M).
Press the ON / OFF button
20 20
again.
E07
An increase in ambient
temperature has turned the
heater off. (The tempera-
ture monitoring system has
worked).
Ventilate the space. Let the
heater cool off. Press the ON /
OFF button
20 20 again.
Filter
E09
The heater has been automa-
tically turned off because the
hot air stream, the ventila-
tor or the ventilator filter
is blocked or hindered by
something. (The safety system
against overheating has
worked).
Remove obstacles from the
ventilator opening. Clean the
ventilator filter (see chapter
M) Press the ON/OFF but-
ton
20 20 again. If the problem
occurs again after taking the
above measures, contact your
dealer.
E13
The heater has been turned
off in a closed space. (The
safety system against incom-
plete combustion has wor-
ked).
Ventilate the space and press
the ON / OFF button
20 20 again.
Ensure the space is sufficien-
tly ventilated.
E17
The heater has been turned
off due to an increased CO2
concentration. (The system
for air quality monitoring has
worked).
Ventilate the space and set
the ON / OFF button
20 20 again.
Ensure the space is sufficien-
tly ventilated.
The ON indica-
tor flashes. Err
lights up
The heater has automatically
stopped because the ON / OFF
button was kept pressed in or
was blocked.
Remove obstacles around the
buttons of the display panel.
Press the ON/OFF button
20 20
again.
F00 – F30
Poor functioning. Heater
needs maintenance
Note the messages displayed
and turn the heater off. Con-
tact your dealer.