3
• First, remove the flange nuts from bolts and place the product through the mounting surface holes.
•
Fasten the flange nuts on the opposite side of the mounting surface until the product is tightened securely.
Lens(AS)
Rubber spacer
Housing(ABS)
LED unit
Reflector
(Heat resistant ABS)
Control panel cover
(ABS)
Resonance chamber
(ABS)
Flange nut
Cover connector
(ABS)
Light bulb
LED unit
Parts Definition/ Installation
Installation Environment and Protection Rating
• This product is designed for use with protection rating of IP54.
• If the product is installed in locations that subject it to excessive dust or water other than the designated IP protection rating indica-
ted(IP54), it may cause malfunction or damage to the product.
• In case of outdoor applications, install the product in the upright or horizontal position. Do not install the product upside-down or in
positions where water can potentially penetrate into the product and impact its operation.
• For further information, please visit our website(www.qlight.com).
• Bit input mode(using external line) allows you to select
one of five sound options by switching on one of the 5
channels (Ch1 - Ch5).
• Total of 5 sound options are configurable.
• Binary input mode(using external line) allows you to
receive multiple inputs by using the 5 channels
(Ch1 - Ch5) to configure one of 30 sound options.
•
Total of 30 sound options are configurable.
■
Bit Input Mode
■
Binary Input Mode
No. 1
2
3
4
5
0
0
0
0
0
0
1
1
0
0
0
0
2
0
1
0
0
0
3
0
0
1
0
0
4
0
0
0
1
0
5
0
0
0
0
1
※
The channel selection method
using a transistor is the same
as the external contact method,
please refer to the figure on
the right.
※
The switch figure to the right
explains how to wire the exter-
nal contacts of a signal line
product. If the product is not a
signal line product, use the
channel selection switch attached
inside the product.
0
0
0
0
0
0
1
0
0
0
0
1
2
0
0
0
1
0
29
1
1
1
0
1
30
1
1
1
1
0
Binary Input Mode
Can select up to 30 sound options
Bit Input Mode
Can select up to 5 sound options
Ch 1 Ch 2 Ch 3 Ch 4 Ch 5
COM
Ch1 Ch2 Ch3 Ch4 Ch5
ON(1)
OFF(0)
Bit/ Binary Input Method Depending on Wiring Method
STND125L-N
STND125LR-N
STND125R-N