4
5
• Machine holes on the mounting surface referring to
the diagram below.
Grounding Instructions
Mounting Hole Specifications
M4 ground contact part
•
Please use an M4 bolt at the location marked in the diagram
above to ground the product.
•
When connecting the grounding cable, please use a ring terminal.
• Please use a grounding cable with a diameter greater than 4mm.
•
First, machine holes on the mounting surface
①
•
The mounting hole of this product is 8.5mm in diameter.
•
When machining taps, fasten the bolt through the mounting hole of
the bracket.
• When machining holes, insert the bolt through the hole of the product,
and tighten the nut from the opposite side of the mounting surface.
■
Installation
Parts Definition/ Installation
■
Parts Definition
Housing(AI)
Cover(AI)
Horn housing
(STS316L)
①
4-Ø9 HOLES
134
134
Installation Environment and Protection Rating
• This product is designed to be explosion proof.
• Please make sure to use the product in an environment that meets the specified explosion proof rating and regulations.
• For further information, please visit our website (www.qlight.com).
Precautions for installation
• In case of outdoor applications, install the product in the upright
position. Do not install the product horizontal or upside-down
positions where water can potentially penetrate into the product
and impact it’s operation.
Left direction
Reverse direction
Right direction
W
ALL
W
ALL
WALL
[Installation]
Summary of Contents for SPNA
Page 6: ...MEMO...
Page 7: ...MEMO...
