3
Parts Definition / Installation/
Sound Selection
2-Ø9 HOELS or
2-M8 TAPS
QWH35T
-TI : PCD
150-163
QWH50T
-TI : PCD
186-202
■
Installation
■Sound Selection - Using Internal Switch (Built-in Sound Type)
• First, make taps or holes that match the product
mounting bolts locations on the mounting surface
①
.
• The mounting hole of this product is 9mm in diameter
(long hole).
• If the tap is machined, fasten the bolt through the
mounting hole of the product.
• When machining a hole, insert the bolt through the
product, insert it into the hole, and tighten the nut from
the opposite side of the mounting surface.
•
Install a flat washer and a spring washer to the bolt if
the product can experience severe vibration and
shock.
2-Ø9 HOELS or
2-M8 TAPS
QWCD35
T-TI : PCD
150-163
QWCD50
T-TI : PCD
186-202
■ Tap Machining
■ Hole Machining
■
Parts Definition
QWH35-TI / QWH50-TI
Body(PC+ABS)
PCB
Cable gland
Horn(PC+ABS)
Resonator(PC)
• For built-in sound type, use ‘Sound Channel Selection Switch’ located inside the product in
order to select the type of sound. (For sound configuration chart, please refer to page 5)
1 2 3 4 5
ON
■
Telephone lines rated power
• Rated power when telephone lines are not in use: 45VDC - 55VDC
•
Rated power when telephone rings : 95VDC - 130VDC(Ring Ring signal sound)
