3
• There’s terminal
①
inside of Solenoid valve box. Please remove a cover by loosening the solenoid
valve box’s bolts.
• Please apply fork (U-type) or ring (O-type) locking spade terminal at naked tip of the wire for secure
connection.
• Please use ex-proof connector or ex-proof cable gland at cable entry
②
in order to keep air tightness.
Product can be damaged by water or dust if the cable entry is exposed outdoor without air tightening.
• Entry of air supply
③
is assembled by using air exclusive house. Please prevent the leakage of air
with sealing material such as Teflon tape or silicon when assembled. Otherwise it causes malfunc-
tion or inoperable status.
• Product can be damaged by water or dust if the air supplying area is exposed outdoor without air
tightening.
①
②
③
Parts Definition/ Installation/ Mounting Hole Specifications
• First, machine taps or holes on the mounting surface
①
.
•
The mounting hole of this product bracket is
10.5
mm in diameter(hole)
•
When machining taps, fasten the bolt through the mounting hole of the bracket.
•
When machining holes, insert the bolt through the hole of the bracket, and tighten the nut from the opposite side of the mounting surface.
■
Parts Definition
/
Installation
• Machine holes on the mounting surface referring
to the diagram below.
■
Mounting Hole Specifications
2-Ø11 HOLES
180
Solenoid valve
box(Al)
Valve Box Cover(Al)
Nipple
①
Installation Environment and Protection Rating
• This product is designed for use with protection rating of IP66.
• If the product is installed in locations that subject it to excessive dust or water other than the designated IP protection rating
indicated(IP66), it may cause malfunction or damage to the product.
•
For further information, please visit our website (www.qlight.com).
Terminal Box Wiring Instructions
