4
• First, remove the flange nuts from bolts and place the product through
the mounting surface holes.
•
Fasten the flange nuts on the opposite side of the mounting surface
until the product is tightened securely.
Cover(ABS)
Long bolt
Rubber spacer
Bolt
Housing(ABS)
Flange nut
Parts Definition/ Installation
• Machine holes on the mounting surface
referring to the diagram below.
Mounting Hole Specifications
Lens(AS)
Control panel cover(ABS)
Resonance
chamber(ABS)
Cover connector(ABS)
Installation Environment and Protection Rating
• This product is designed for use with protection rating of IP54.
• If the product is installed in locations that subject it to excessive dust or water other than the designated IP protection rating indica-
ted(IP54), it may cause malfunction or damage to the product.
• In case of outdoor applications, install the product in the upright or horizontal position. Do not install the product upside-down or in
positions where water can potentially penetrate into the product and impact its operation.
•
For further information, please visit our website(www.qlight.com).
STNDL-N/ STNDLF-N
3-Ø6 HOLES
Min.Ø5 CABLE ENTRY
PCD70
How to Change Lens Kit
②
③
①
• When rearranging or replacing the lens kits, please be aware of the
contact point
①
and the connector pin
②
marked in the diagram on
the left.
• Press down to assemble the lens kits while making sure that connector
pin
②
and connector
③
aligns correctly.
• Please make sure that the rubber spacer placed on the top of each
lens kit is tightly secured to the bottom of the other lens kit.
※
Caution when lens kit
• Lens kits are connected with connector pins each other. Bad connec-
tion may be experienced when the connector pins are touched with a
foreign substance.
•
If the lens kits are not turned on or not flashed after lens kits replace-
ment, please make sure status of lens kit connection.
