3
①
• First, machine taps or holes on the mounting surface
①
.
• The mounting hole of this product is 8.5mm in diameter.
• When machining taps, fasten the bolt through the mounting hole of the product.
• When machining holes, insert the bolt through the hole of the product, and tighten the nut from the opposite side of the mounting surface.
■
Installation
Protection cage
(STS316L)
Lens(Tempered glass)
Housing(Al)
Bell(Al)
• •
Please refer to the chart below to use light function
selection switch located inside the product.
• Default function is set at steady LED. Select the desired function
for your application during installation.
4-Ø9 HOLES
134
134
•
Please use an M4 bolt at the location marked
in the diagram above to ground the product.
•
When connecting the grounding cable,
please use a ring terminal.
• Please use a grounding cable with a diam-
eter greater than 4mm.
Terminal Box Wiring Instructions
• Terminal block is located inside of the product. Unscrew the 4 bolts located in the upper body to
get rid of the upper lighting element of the unit.
• Please apply fork (U-type) or ring (O-type) locking spade terminal at naked tip of the wire for
secure connection.
• Please wire the power line to terminal
①.
• For AC type products, wire regardless of polarity.
• For DC type products, wire terminal of black line to (-) polarity.
• Once the unit is powered on, light and bell are working simultaneously.
Parts Definition/ Installation/
Light Function Selection
▶LF :
Flashing
■
Light Function Selection(SEBAL only)
▶L :
Steady
■ Parts Definition
Grounding Instructions
Mounting Hole Specifications
• Machine holes on the mounting surface referring to
the diagram below.
M4 ground contact part
①
Summary of Contents for SEBA
Page 6: ...MEMO...
Page 7: ...MEMO...
