PCD 96
3-Ø6 HOLES
PCD 155
3-Ø6 HOLES
Min. Ø
5 CABLE ENTRY
Min. Ø
5 CABLE ENTRY
PCD 96
3-Ø6 HOLES
PCD 155
3-Ø6 HOLES
Min. Ø
5 CABLE ENTRY
Min. Ø
5 CABLE ENTRY
Disassemble
bulb
Disassemble
bulb
• Machine holes on the mounting surface referring to
the diagram below.
■
Mounting Hole Specifications
Mounting Hole Specifications/ Xenon Bulb Replacement lnstructions
■
Xenon Bulb Replacement instructions
•
Please wait at least 30 mimutes after turning off the power before replacing the xenon bulb.
• Please pull out the entire xenon bulb structure
①
to disassemble.
•For xenon bulb assembly, please ensure the connector portion of the xenon bulb structure matches the pin location
②.
①
①
②
②
3
S150US/ S150UHS
S150US-FT/ S150UHS-FT
S150US/ S150US-FT
S150UHS/ S150UHS-FT
Assemble
bulb
Assemble
bulb
Installation Environment and Protection Rating
• This product is designed for use with protection rating of IP44.
• If the product is installed in locations that subject it to excessive dust or water other than the designated IP protection rating
indicated(IP44), it may cause malfunction or damage to the product.
• In case of outdoor applications, install the product in the upright position. Do not install the product horizontal or upside-
down positions where water can potentially penetrate into the product and impact it’s operation.
• For further information, please visit our website (www.qlight.com).
