5
3-Ø9 HOLES
PCD 155
①
Parts Definition/ Installation/ Light Function Selection
•
First, machine taps or holes on the mounting surface
①
.
•
The mounting hole of this product is 8mm in diameter.
•
When machining taps, fasten the bolt through the mounting hole of
the product.
•
When machining holes, insert the bolt through the hole of the
product, and tighten the nut from the opposite side of the mounting
surface.
■
Parts Definition/ Installation
■
Light Function Selection
Protection cage
: STS316L
Lens
(Tempered glass)
Housing(AI)
• •
Please refer to the chart below to use light function
selection switch located inside the product.
• Default function is set at steady LED. Select the desired function
for your application during installation.
Light function
No. 1
2
Operation
0
0
0
Steady LED
1
0
1
Flashing LED
2
1
0
Strobe LED
3
1
1 Simulated revolving/
flashing LED
ON(1)
OFF(0)
Installation Environment and Protection Rating
• This product is designed for use with protection rating of IP66.
• If the product is installed in locations that subject it to excessive dust or water other than the designated IP protection rating
indicated(IP66), it may cause malfunction or damage to the product.
• For further information, please visit our website (www.qlight.com).
Mounting Hole Specifications/ Grounding Instructions
• Machine holes on the mounting surface
referring to the diagram below.
QNE/ QNES
■ Mounting Hole Specifications
■ Grounding Instructions
M4 ground contact part
•
Please use an M4 bolt at the location marked in the diagram above
to ground the product.
•
When connecting the grounding cable, please use a ring terminal.
•
Please use a ring terminal made of C5212 material as it has the
same electrical properties of the conductor.
• Please use a grounding cable with a diameter greater than 4mm.
Light function
selection switch
Summary of Contents for QNE
Page 7: ...MEMO...
