QisDESIGN BE Light ZR11 _F, User Manual, Page: 5 / 20

English 2
Installation
1. Place the lamp base on a solid, flat and stable surface. Insert the shaft on the lamp base into
the hole on the bottom of the lamp body. (Figure )
2. Secure the lamp base to the lamp body by installing the supplied screw and tightening it using
a suitable cross-head screwdriver. (Figure a )
3. Remove the plastic film that bundles the lamp arm and lamp body. (Figure )
4. Connect the power cord from the lamp body to the connector on the power adapter, and
then plug the power adapter into a wall power outlet. (Figure )
5. Adjust the lamp arm to your desired angle and position. Note that the lamp arm is not
designed for 360-degree rotation, so there are two protrusions on the lamp arm that are used
to limit the rotation angle. (Figure
) Do not rotate the lamp arm any further when it is
stopped by the protrusions.
Using the Lamp
Turning on/off the Lamp and Adjusting Brightness
Folding the Lamp
When the lamp is flattened, the lamp arm can be attracted to the lamp body by a built-in magnet.
(Figure
). To avoid dents and scratches, do not push the lamp arm too hard against the lamp
body when folding the lamp.
Maintenance and Troubleshooting
Cleaning the Lamp
Turn off the lamp first, and unplug the lamp from the power outlet. Wipe any smears or dusts off
the lamp's outer casing using a soft, lint-free cloth lightly moistened with a mild detergent
solvent. Do not use alcohol or any other chemical solvents like kerosene, naphtha and so on, as
the lamp's casing may become damaged.
Cleaning the Wiring
• Turn off the lamp first, and unplug the lamp from the power outlet. Wipe the lamp's wiring
clean using a soft, lint-free cloth lightly moistened with a mild detergent solvent. Never use a
wet cloth, as it may cause an electric shock.
• Do not rinse the lamp or any of its components directly with water.
Troubleshooting
If the lamp does not turn on, check to make sure that there are no loose connections between
the lamp, power cord, power adapter, and the power outlet.
If the problem persists, please contact the original place of purchase for help.
Specifications
www.QisDesign.com
1
2
3
4
5
• Press the power button on the lamp body to turn on the lamp. To turn off
the lamp, press the power button again.
• To adjust lamp brightness, press and hold the power button and the
brightness will change gradually. When the brightness reaches your
desired level, release the power button.
6
Model ZR11 _F
DC power input
12V, 1.5A
Max. power consumption
12W
Dimensions
Refer to Figure (Unit: mm)
7
BE_floor.book Page 2 Tuesday, August 28, 2012 3:53 PM