User manual | Qimova chair
Page 36 of 48 | Version 1.10
7
Passing obstacles
7.1
Kerbs
Do not attempt to drive over kerbs or obstacles. Doing so may cause the wheelchair to tip
over and cause bodily harm or damage the chair.
7.2
Ramps
When climbing up or down ramps put the chair in upright position and make sure that the
anti-tip is in the correct position facing downwards See Figure 12. Do not climb up or down
ramps with slopes greater than 6º.
7.3
Steps and steep terrain
This chair is a class B wheelchair designed primarily for indoor use. However, it can be
used outside on flat, hard and homogenous surfaces.
The chair is not designed to overcome obstacles like steps or steep terrain. Please see
Safety and misuse warnings and Operation information.
8
Accessories
8.1
Headrest
8.1.1
Headrest adjustment
The following section covers how to adjust the standard headrest.
Combi arm bracket
The combi arm bracket is useful where
adjustment of the headrest back/forth and
up/down is needed. The adjustments are
done using the two handles (A). The
height is adjusted by first loosening the
bracket (B) and the handle (C). Tighten
them again after the desired position has
been achieved.
To remove the headrest use the handle (C)
Weight: 1.25 Kg
The bracket (B) ensures that the settings
of the headrest are maintained after
remounting.
Figure 31