Qilive Q.6353, User Manual

Page: 10 / 124

10
EN
3. Ensure sufficient air circulation at the rear of the appliance. Do not place the appliance
against a wall to avoid noise caused by vibration. Make sure that the air can still
circulate freely around the appliance. Insufficient ventilation would result in malfunction
and increased energy consumption. Leave a space of at least 10 cm between the
refrigerator and the side walls (F), 5 cm at the rear (E) and 30 cm between the top of
the refrigerator and the ceiling. The door opens to an angle of 130 ±5° (C) and (A) and
(B) is the space needed for opening the doors (

Fig. 2).
4.3 Level feet
If the appliance tilts in some way, adjust the height of the left/right foot (7) of the appliance
to be in a horizontal level (

Fig. 3).
Turn the foot (7) clockwise or counter clockwise to adjust the height.
Note: If the appliance is not level, the door and the door seal will not be closed properly.
4.4 Positioning
Install this appliance at a location where the ambient temperature corresponds to the
climate class indicated on the rating plate of the appliance. This ensures the correct
operation of the appliance.
Climate class Ambient temperature
SN +10°C to +32°C
N +16°C to +32°C
ST +16°C to +38°C
T +16°C to +43°C
4.5 Electrical connection
Before plugging in, ensure that the voltage and frequency shown on the rating plate
correspond to your domestic power supply. The appliance must be earthed. The power
supply cable plug is provided with a contact for this purpose. If the domestic power
supply socket is not earthed, connect the appliance to a separate earth in compliance
with current regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above safety precautions are not
observed.
5. USE
5.1 First use
Before using the appliance for the first time, wash the interior and all internal accessories
with lukewarm water and some neutral soap so as to remove the typical smell of a brand
new product, then dry thoroughly.
Important! Do not use detergents or abrasive powders, as these will damage the finish.
5.2 Temperature setting
Connect your appliance to mains power. The internal temperature of the refrigerator is
controlled by a thermostat (12) with 7 settings. 1 is warmest setting, 6 is coldest setting
and 0 is off (

Fig. 4).
The appliance may not operate at the correct temperature if it is in a particularly hot
position, if you open the door very often or leave it standing open.