15
15
EN
4. INSTALLATION
4.1 Installation Area
Warning!
•
Stability is important to prevent the product from wandering!
• Make sure that the product should not stand on the power cord.
Before installing the washing machine, the location characterized as
follows shall be selected:
1. Rigid, dry, and level surface.
2. Avoid direct sunlight.
3. Sufficient ventilation.
4.
Room temperature is above 0°C.
5. Keep far away from heat resources such as coal or gas.
4.2 Unpacking the Washing Machine
Warning!
• Packaging material (e.g. films, styrofoam) can be dangerous for
children.
•
There is a risk of suffocation! Keep all packaging well away from
children.
1. Remove the cardboard box and styrofoam packing.
2. Lift the washing machine and remove the base packing. Make
sure the small triangle foam is removed with the bottom one
together. If not, lay the unit down on its side surface and then
remove the small foam from the unit bottom manually.
3. Remove the tape securing the power supply cord and drain hose.
4. Remove the inlet hose from the drum.
4.2.1 Removing the Transport Bolts
Warning!
•
You must remove the transport bolts from the backside before using the product.
•
You will need the transport bolts again if you move the product, so make sure you
keep them in a safe place.
Please take the following steps to remove the bolts:
1. Loosen 4 bolts with a spanner and then remove them.
2. Stop the holes with the transport hole plugs.
3. Keep the transport bolts properly for future use.
4.3 Levelling the Washing Machine
Warning!
•
The lock nuts on all four feet must be screwed tightly against the housing.
1.
Check if the legs are closely attached to the cabinet. If not, please turn them to their
original positions and tighten the nuts.
2. Loosen the lock nut and turn the foot until it closely contacts with the floor.
3. Adjust the legs and lock them with a spanner, make sure the machine is steady.
Raise
Lower
foot
Lock nut
