Qiagen PyroMark Q96 ID, User Manual, Page: 29 / 126

Installation Procedures
PyroMark Q96 ID User Manual 01/2016 4-3
4.3 Moving the PyroMark Q96 ID
WARNING Risk of personal injury and material damage
[W2]
The PyroMark Q96 ID is too heavy to be lifted by one
person. To avoid personal injury or damage to the
instrument, do not lift the instrument alone.
If you need to transport the PyroMark Q96 ID, package the
instrument as follows:
1.
When the instrument is not processing, shut down
PyroMark Q96 Software and exit from Microsoft
Windows.
2. Switch off the operator’s computer and PyroMark Q96 ID
and disconnect the mains power cable from the
instrument.
3. To move the instrument to a new location within the
same laboratory, go to step 4. To move the instrument to
another site, go to step 7.
4. Place the instrument onto a trolley and move to the new
location.
Note : The instrument weighs 52 kg. Two persons are
required.
5. Position the PyroMark Q96 ID on the bench. See Section
4.2 for site requirements.
6. Follow the reinstallation procedures in Section 4.4 for
stand-alone installation or Section 4.5 for network
installation.
7. To move the instrument to another site: First, mount the
transport protection block under the instrument lid.
8. Pack the PyroMark Q96 ID and other components using
the original packaging supplied with the instrument, if
available.
Note : The total weight of the package including the
instrument is 80 kg. The instrument alone weighs 52 kg.
Use suitable lifting equipment when moving the
package.