20
– 07|2020 – Subject to change without notice.
Speedkid 2020
The table below shows the main settings that you must make for particular components for the
respective mode:
Component
Status of the components in mode
Trailer
Buggy
Walker
Buggy-wheel
must be completely
removed
fitted
(freely rotating)
fitted
(fixed)
Tow bar
directed forwards
(pay attention to tow
bar load!)
directed backwards
directed backwards
Pennant
must be mounted
recommended
recommended
Push handle
10 - 15 cm
above the roof
of the cabin
comfortable height
comfortable height
Hand strap on the
push handle
–
wrapped around a
wrist
wrapped around a
wrist
5-point safety harness
must be fastened
must be fastened
must be fastened
Rear light
must work in poor
visibility or darkness
(observe StVZO)
recommended in
poor visibility or
darkness
recommended in
poor visibility or
darkness
Bicycle
the correct coupler
must be installed
–
–
Danger!
Before every journey, make sure that necessary adjustments have been made
for the particular mode. For details of this, see the instructions in the following
sections.
Adjusting the buggy wheel
You must make the following settings, depending on the mode.
Removing the buggy wheel (Trailer mode)
The buggy wheel must not be fitted in Trailer mode, because in certain riding situations it can
make contact and cause serious accidents.
»
Slightly lift the cabin at the front.
»
Push the release button at the wheel mount and remove the buggy wheel completely.
Tip!
Carry the buggy wheel e.g. in the storage space in order to allow you to use the
flexibly at your destination. Instructions for re-mounting it can be found in the
chapter
„Installing the buggy wheel“ on page 15
.
Utilisation
