10
14) PLUNGE CUTTING (Fig 8)
WARNING: ALWAYS clamp and support workpiece securely, ALWAYS make sure the
workpiece is securely positioned so it will not move.
1) Unplug the Multi Saw.
2) Mark the cut line on the surface to be cut.
3) Set the cutting depth to the thickness of the material to be cut.
4) Align (position) the Multi Saw base on the workpiece to your mark. Using the mark line
at the side of base, so that you can know the start and end edge of the blade.
5) Plug in the Multi Saw.
6) Hold the Multi Saw firmly with both hands.
7) Activate the trigger back to turn the Multi Saw “ON”.
8) Let the blade reach full speed.
9) Release the blade guard release lever.
10) A.
SLOWLY lower the blade into the workpiece.
B. Carefully guide the Multi Saw through the line of cut until the mark line at the side of
base aligns with the end of cut marking on your workplace. (DO NOT bind the blade in
the cut; push the Multi Saw blade forward at a steady rate where the blade is not
laboring).
C. When the cut is complete, release the trigger switch and let the blade come to a
complete stop. DO NOT REMOVE the Multi Saw and blade from the workpiece while
the blade is moving. This could damage your cut, cause loss of control, resulting in
serious injury.
11) When the blade and Multi Saw are clear of and removed from the workpiece, the lower
blade guard and base will be able to automatically drop down and the blade guard
release lever will engage the upper blade guard, locking the blade above the base.
Tel: 01335 347300
Fig 7 Edge Guide
Edge Guide