QEP 60707, Instruction Manual

Page: 6 / 14

wear, or looseness. Replace any
damaged or worn parts. ALWAYS
DISCONNECT FROM POWER BEFORE
CHANGING OR ADJUSTING THE
BLADE.
9. Blade direction
Check that the directional arrow on the
saw blade and the motor shaft are rotating
in the same direction.
10. Blade arbor
Ensure the blade arbor hole size matches
the arbor shaft size on the tile cutter.
11. Blade guard
Do not operate the tile cutter without blade
guard installed and properly adjusted.
12. Blade speed
Do not exceed the safe operating speed of
the blade.
13. Side grinding
Do not use the blade for grinding purposes,
e.g. for grinding the edge of a tile after
cutting it. Do not carry out radius or curve
cuts.
This Tile Saw is recommended and
warranted for domestic use only
Run down time
The run down time of the blade is 40 seconds
after switching off the power. Wait until the
blade stops completely, and then pull out the
plug from the mains socket. Only after this are
you allowed to touch rotating parts if
necessary.
Prevent any contact with rotational tool
during the operation
TECHNICAL SPECIFICATIONS
Technical specifications
Model
Voltage
Frequency
Power input
No load speed
Saw Blade dimensions
(Continuous rim diamond
blade only)
Insulation class
Protection degree
Max. cutting depth (90
0
)
(45
0
)
Work table dimensions
Nominal mass
Max. operating mass
L
pa
(sound pressure level)
L
wa
(sound power level)
60707
230V~240V
50Hz
350W (S
1
)
600W (S
2
:20min)
3,000min
-1
Φ 180X Φ 22.2mm
Class B
IP 54
35mm
22mm
330X360mm
10kgs
12kgs
66.3 dB(A)
79.3dB(A)
Remark: S1 means continuous operation
S2 30min means short-time
operation for 20min
Electrical Safety
WARNING!
Always check that the power
supply corresponds to the voltage on the
rating plate.
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It
is dangerous to insert the plug of a loose cable
in the wall outlet.
Using extension cables
1. Always use a three (3) core extension lead
having a conductor size of at least 1.0mm
2
and a length not exceeding 20 metres
2. Only connect your machine and/or
extension cable to an earthed power point.
If in doubt about the earthing of the power
point, consult an electrician.
3. Even considering variations of the power
- 6 -