QEP 21665Q, Owner'S Manual

Page: 7 / 24

MAINTENANCE AND TROUBLESHOOTING
CAUTION: Be sure to switch power OFF and disconnect the plug during maintenance
and inspection.
1. Use a mixing paddle appropriate for the material you are mixing.
2. This power mixer normally requires little maintenance. It is suggested that
the ventilation space between the gear box and the motor be cleared of
debris after each use.
3. After approximately 100 hours of use, check the motor brushes and replace,
if necessary.
4. Store mixer in a dry place that will not freeze.
Motor Unit:
Power Input: 1300 Watts
Voltage: 120V-60HZ
No Load Speed: Low: 180-460 RPM, High: 300-700 RPM
Certification: ETL
Mixing Paddle: 127 mm (5”)
Weight: 13 lbs., 9oz
Double Insulated
SPECIFICATIONS
CUSTOMER AND TECHNICAL SERVICE
For customer and technical service please go to www.qep.com
or call tollfree 1-866-435-8665.
e. Run the mixer at low speed using the variable speed dial until the dry
material and water are evenly distributed. Do not run the mixer at high
speed if it appears to be slowed down or labored. If the mixer begins to heat
up, allow it to cool, then run at a lower speed.
f. When finished mixing, remove the mixing paddle from the mixer. Wipe any
water, mud or debris from the mixer with a clean, dry cloth. Wash the
mixing paddle with clean water. Do not allow grout, mortar or paint to dry
on the mixing paddle.
OPERATING INSTRUCTIONS -
CONTINUED
- 7 -