QEM MDO P1P44F-010, Operator'S Manual

Page: 37 / 57

MDO_P1P44F-010: Operator Manual
35/55
13.0.1 Working parameters
Y width Total width of the part to be flattened.
Y step The value of the pitch that covers the Y axis after each cut.
Z depth
Cut Depth.
Used if lowered cut is set.
Z step
The value of the step that covers the Z axis with each pass.
Used if lowered cut is set.
13.0.2 Axes parameters
Self-learning positions X1 + X2 = Software limit switch of cutting
N.B. the disc must exit the slab before learning the X1 - X2 dimensions
13.0.3 Working parameters
CUT TYPE
SINGLE one pass TO LOWERED multi-pass
CUT DIRECTION
X+ Forward only BILATERAL to greek
Y DIRECTION
POSITIVE The move of Y takes place in the positive
direction
NEGATIVE The move of Y takes place in the negative
direction
END CYCLE
The axes STOPPED when the cycle is end The disk goes to PARKING at the end of the cycle