1.7.1
Slate Message Overlay
This mobile application allows to send a text message to a SLATE106 device which is displayed over the existing picture in a predefined area for a specific duration.
Configuration
The mobile application uses the
WPAN2
connection of the SLATE106 device. So the
Pictureframe
application must be configured to support
WPAN2
connections. If
required execute
APPLI.HTA
from your SLATE, and check that:
In the
Actions
screen, check that the
Receive Message Overlay over WPAN2
option is activated for the Wake-up source column
After Vibration
.
In the
WPAN
screen, check that the
Message Overlay
feature is activated.
If not needed, it is advised to inactivate the support of the Touch key.
Pairing to a SLATE106
If not done, install the application
Slate Message Overlay
on your mobile device. For further information about this application, contact [email protected].
Launch the application
Slate Message Overlay
on your mobile device and press
Clic here to pair a SLATE
to see the list of the SLATE available and near to your
mobile device:
List of the available pairable SLATE106 devices:
If the list is empty, wait for a while until some SLATEs are detected.
If not yet detected in the list after few seconds, if you are close to your SLATE106 device, wake it up by taping the device with your phone allowing to generate a wake by
vibration. Your SLATE106 device appears immediately. On the mobile application, press on the SLATE106 device detected
that you want to pair:
Once selected, if a PIN code is required, enter a pincode (between 0000 and 9999) and note it preciously. Enter the same pin code each time you are pairing this SLATE.
1
2
3
45
