Qeedji AMP300, User Manual

Page: 37 / 87

37
Device configuration by server TFTP and server DHCP with code 66
The AMP300 device can be configured thanks to a configuration script hosted on a TFTP server + DHCP server (code 66).
Prerequisites:
the LAN or the WLAN interface is configured in DHCP mode,
a TFTP server and a DHCP server are properly configured, are working properly and are available on the network. For further information, refer to
the chapter § TFTP and DHCP server configuration ,
the Javascript configuration script is available in the exported directory of the
TFTP server
,
a new configuration script is taken into account by the device only when a modification has been done and only after a device restart.
At each device boot-up, the JavaScript configuration script is downloaded from the TFTP server. The script is then executed once only if it has never
been downloaded before or if the configuration script has been modified since the last reboot. The message should be displayed showing the IP
address of your TFTP server.
Then you should see the same messages as the chapter § Device configuration by USB (after the USB storage device is unplugged).