QED LANDTEC i-Q Series, Operation Manual

Page: 41 / 51

Operation Manual
GEM and GEM PRO
OMiQGEM-L Issue.02
Page 41 of 51
7) Replace the pressure module, ensuring the connector on the Carrier PCB aligns with the socket on the
base of the module.
Note: Care is to be taken when aligning
Figure 17 – Pressure Module Alignment
8) Replace the case back and secure it in place with the retained screws and the Phillips No.1 screwdriver
Figure 18 – Case Back Fitting
9) Tighten the inlet port plate screws using the Phillips No.1 screwdriver
Figure 19 – Inlet Port Plate Fitting
10) Place the replacement battery pack (QED part number PMMPB) into the case back recess. It will only fit
one way and will automatically align itself.