Manual for ZillioX 9
Wake-Up On LAN (WOL)
Through the Wake-Up On LAN function, a wake event occurring from the network can
wake up the system. If this function is to be used, please be sure an ATX 2.01 power
supply of which 5VSB line is capable of delivering 720mA, and a LAN adapter which
supports this function are used. Then connect this header to the relevant connector on the
LAN adapter, set “PowerOn by Ring/LAN” as Enabled in the “POWER MANAGEMENT SETUP”
section of the BIOS. Save & exit, then boot the operating system once to make sure this
function takes effect.
Wake-Up On Internal Modem (WOM)
Through the Wake-Up On Internal Modem function, the system which is in the power-off
status can be powered on by a ring signal received from the internal modem. If this function
is to be used, be sure an internal modem card which supports the function is used. Then
connect this header to the relevant connector on the modem card, set “ PowerOn by Ring/
LAN ” as Enabled in the “POWER MANAGEMENT SETUP” section of the BIOS. Save & exit,
then boot the operating system once to make sure this function takes effect.
Sound Connector (PC-PCI)
This connector is for the usage of PCI sound card.
Installation Instruction
12
1
+5V standby
GND
Signal for waking up (active low)
1
+5V standby
GND
Signal for waking up (active high)
GND-2
PC/PCI DMA ACKNOWLEDGE-1
SERIAL INTERRUPT REQUEST-6
NC-3
GND-5
4-PC/PCI DMA REQUEST
