Installation Instructions
K8VM800
10
Wake-Up On LAN (WOL)(available on -L mainboard)
Through the Wake-Up On LAN function, a wake event occurring from the network can
wake up the system. If this function is to be used, please be sure an ATX 12V power
supply and a LAN adapter which supports this function are used. Then connect this
header to the relevant connector on the LAN adapter, set “modem ring resume” as
Enabled in the “POWER MANAGEMENT SETUP” section of the CMOS SETUP. Save and
exit, then boot the operating system once to make sure this function takes effect.
IEEE 1394_1 port(optional)
Besides one 1394 port on the back panel, the mainboard also have one 10-pin header on
board to provide IEEE 1394 port.
Signal for waking up
WOL
+5V standby
GND
1
1394_1
VCC
B0-
A0-
A0+
1
B0+
GND
CUT
VCC
GND
GND
