QDI K8V800, Manual

Page: 16 / 56

8
QDI QDI QDI QDI QDI
Installation Instr Installation Instr
Installation Instr Installation Instr
Installation Instruction uction
uction uction
uction
Hard Disk LED Connector (HDD_LED)
The connector connects to the case’s IDE indicator LED indicating the activity status of IDE
hard disk. The connector has an orientation. If one way doesn’t work, try the other way.
Reset Switch (RESET)
The connector connects to the case’s reset switch. Press the switch once, the system resets.
If you change “Soft-off by PWR-BTTN” from default “Instant-off” to
“Delay 4 Sec” in the “POWER MANAGEMENT SETUP” section of
the BIOS, the power switch should be pressed for morethan 4
seconds before the system powers down.
Note:
ATX 12V Power Supply Connector & Power Switch (POWER SW)
The power switch (POWER SW) should be connected to a momentary switch. When powering
up your system, first turn on the mechanical switch of the power supply (if one is provided),
then push once the power switch. When powering off the system, you needn’t turn off the
mechanical switch, just push once the power switch. The mainboard only support ATX12V
power.
POWER SW
1
ATX Power Supply Connector
20
1
12V
5VSB 5V GND 3.3V GND 5V GND PS-OK 3.3V
5V 5V -5V GND PS-ON -12V 3.3V GND GND GND
12V
12V
GND
GND
+12V Power Supply Connector
1