Manual for Advance 12 series
Chapter 2
Wake-Up On Internal Modem (WOM)
Through the Wake-Up On Internal Modem function, the system which is in the suspend or
soft-off status can be waked up by a ring signal received from internal modem. If this
function is to be used, be sure an internal modem card which supports the function is used.
Then connect this header to the relevant connector on the modem card, set “Wake up on
LAN/Ring ” as Enabled in the “POWER MANAGEMENT SETUP” section of the BIOS. Save &
exit, then boot the operating system once to make sure this function takes effect.
Internal Audio Connectors (AUX, CDLIN, MODEM)
( Available on Advance 12-A/-AL/-C/-CL )
AUX and CDLIN connectors allow you to receive stereo audio input from such sound sources as a
CDROM, TV tuner, or MPEG card. The MODEM connector allows the onboard audio to interface with
a voice modem card with a similar connector. It allows connecting the mono_in (such as a
phone) or mono_out (such as a speaker) between the onboard audio and the voice
modem card.
1
+5VSB
GND
Signal for waking up (active low)
Left Audio Channel
Phone-In (from Modem)
Right Audio Channel
AUX
GND
Common
Mono-Out (to Modem)
GND
MODEM
CDLIN
Right Channel
Left Channel
1
1
1