8) How to use
-
D
irection switch on the fan ‘s remote.(FORWARD and REVERSE switch)
-
D
own for summer make the air movement directly from ceiling.
-
U
P for winter, to circulate the warm air generated by heater to floor.
9) Remote Control Instruction
T
his ceiling fan can be installed with remote control, but make sure you know how to install the device in safe way or
consult licensed electrician
W
arranty may be affected if you install the improper remote control or install it in improper way.
(1) WIRING SCHEMATIC DIAGRAM FOR RECEIVER
Adopt RF wireless digit emission technique, biunique controlled , coincident code rate is less than one millionth.(Emitter and receiver must be
sent back to factory for maintenance if damaged.)
Receiver can be controlled by any angles of the emitter in prescriptive space, unrestricted by direction. With the memory function, the controller
can save the status( light and direction ) while the supply power OFF and resume to the original after reload the power supply.
(2) FUNCTION INSTRUCTION OF EMITTER
Notes:
1) Power on, the light on with 3500K
2) Push LIGHT ON/OFF button the 1st time, the light off
3) Push LIGHT ON/OFF button the 2nd time, the light on with 2700K
4) Push LIGHT ON/OFF button the 3rd time, the light off
5) Push LIGHT ON/OFF button the 4th time, the light on with 3000K.
6) Push LIGHT ON/OFF button the 5th time, the light off
7) Push LIGHT ON/OFF button the 6th time, the light on with night light function.
(3) KINDLY REMINDERS:
1. Learning code matching mode is used between emitter and receiver. Turn "ON” the supply power within 30 seconds and press the emitter's
"FAN ON/OFF" button for 5 seconds, it can load normally after hearing a long sound “bee”
，
which means learning successfully and it can
works normally. (PS: Learning mode is not accepted after turn "ON” the supply power for 30 seconds)
2. When the emitter cannot control the receiver, please check the battery switch touching normally or not, correction of the positive and
negative, full or empty of the power.
3. When the emitter cannot control the receiver, please check is there any existence of similar remote controlled products nearby, then check
whether they works, because remote controlled product with the same frequency will disturb each other.
4. Low voltage of battery will affect the sensitivity of the emitter and the signal reception accordingly (the indicated light will flash out its
warning when the battery get low voltage), must replace if the battery is getting low voltage.
5. Please take out the battery from the emitter when leaving unused for long time.
6. The maximum load of lighting see the above
H
POWER PARAMETER LIST"
PS
：
please connect the ground wire correctly,otherwise it may cause the light micro-light or flash
7. When installing the fan,the fan ceiling cover don't press the antenna(or other wire),it is easy to breakdown
the wire and short-circuited.
P.6
