Scout WL Dark Grey
92301
INSTRUCTION MANUAL
█
INSTALLATION STEPS
1. Press under the Wall mounting plate then pull out the main body.
2. Use the Wall mounting plate to mark the position of screw holes onto mounting surface.
4. Drill the wall to depth of about 30 mm and fit the plastic plugs.
5. Fix the Wall mounting plate to the mounting surface with rightly screws. Care should be taken to
avoid drilling or screwing into concealed electrical wiring.
6. Turn the switch to “AUTO” position
7. Mounting the Main unit onto the Wall mounting plate.
8. Screw the rightly screw (supplied) under the main unit.
█
FINAL ADJUSTMENT AND START-UP
After you successfully installed your SOLAR PIR SENSOR LIGHT,
you are almost ready for carefree operation with a few final steps:
Initial 3-days Charge:
On the main unit there is a dial switch with 2 positions:
●
OFF
●
AUTO
AUTO —
Position for normal operation of unit.
OFF ---
1) Position for shipping or extended periods of non-use
2) Position for initial 3-day charge before final adjustment and first use. (Although the unit can
charge, it is not operational in this mode)
For now, turn the dial switch to OFF position. In this position the solar cell will charge the battery
without activating the unit. Leave the switch in this position for 3 sunny days to ensure that the battery
has a full charge prior to motion sensor adjustment and normal operation.
█
Walking-test:
Point the motion sensor to face the area you want to detect motion in.
At night, walking slowly in its detection area, the sensor can detects moving invisible infra-red radiation
given off by a human body and then turn on the light. Test the coverage of the area by walking slowly
around until not to switch on the light.
█
STORAGE
If you wish to store your light indoors for more than two or three days, follow these steps to prevent
damage to battery:
1. Turn the switch to OFF position
2. Store the light and solar panel where it can receive some sunlight or room light each day.
The battery needs light to maintain a charge during storage
█
NOTE THE FOLLOWING TROUBLE-
SHOOTING:
1. Symptom: Light won’t activate in normal operation.
Correction:
The main unit switch is the AUTO position.
The motion sensor is positioned to face oncoming movement
Change the battery
2. Symptom: Light turns on during the day.
Correction: Make sure that
■
The unit mustn’t in shadow area.
3. Symptom: Light is not as bright as normal.
Correction:
■
Change the battery.
■
■
■
