PREFACE
Y
our ceiling fan may sometimes have wobble problem when operate due to irregularity in blades or the blade holder. Also, improper assembly in
the mounting system may cause some additional problem also bearing crooked. The following procedure to remedy such problem is strongly
recommended by us from our past experience in handling the wobble problem.
D
ynamic blade balancing kit for ceiling fans
1.
M
ake sure that all blade are firmly screwed into the blade holder
2.
M
ake sure that all blades are firmly secured the flywheel and check pitch of blade holders all must be the same
3.
B
y looking up the fan from below, check and be certain that none of the blade holders are bent so that none of the blade is out of position.
A correction can be made by very gently bending the blade holder back into position
4.
B
y the simple use of a household yardstick blade tracking can be checked, out the yardstick up against the ceiling vertically and even with
the outside leading edge of a blade. Note the distance of the edges of the blade to t he ceiling; carefully turn the blade slowly by hand to check
the remaining blades. If blade is not in alignment, the blade holder may be gently bent up or down to be in line with the other blades
I
f by following all the steps and the wobble problem is not solved, a dynamic balancing need to be done by the use of the balancing kit. Follow the
procedure listed below:
T
urn the fan on and adjust the speed control (usually high speed) setting to the speed, which creates to greatest wobble.
T
urn the fan off; select on blade place the balance clip on it. Halfway between the blade holder and the blade up on the rear edge of the blade.
T
urn the fan on, watch to see of the wobble is improved or worse. Then, turn the fan off again and move the clip to another blade and test
again. Repeat this process with all blades and then note that blade which is the most improved.
M
ove the clip back to the blade, which showed the most improvement. Move the clip inward and outward on this blade and operate t he
fan to find the position where the clip gives the most improvement
N
ext remove the clip and install a balancing weight to the top of the blade along the centerline near the point where the clip was positioned.
C
aution: stay clear of the blades if the clip for any reason is not secured, injury could result
12. Others
H
ave your product repaired by a qualified person
T
his electric product is in accordance with the relevant safety requirements. Repairs should only be carried out by qualified persons using original
spare parts; otherwise this may result in considerable danger to the user. This appliance can be used by children aged from 8 years and above if
they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved. Cleaning
and user maintenance shall not be made by children unless they are older than 8 and supervised. Keep the appliance and its cord out of reach of
children aged less than 8 years.
P
lease contact the store which you bought the product for after sale services if
question
P.11
