Main Unit:
The main unit contains the 2*6*0.5W LED, motion sensor and battery
(
Ni-MH Rechargeable battery, 3.6V 2200mAh
). When deciding where
to mount this unit, keep in mind that the motion sensor that actives
the light has a “field of vision” of min. 8 meters (in front of the light)
and about 130º (horizontal) at 25
℃
environmental temperature.
Solar Cell:
The solar cell is the power source for the SOLAR PIR SENSOR LIGHT. It
converts the sun’s energy into electricity that charges the battery
stored in main unit. This requires DIRECT SUNLIGHT falling onto the
face of solar cell for as long as possible over the course of day.
Use the three screws supplied (#4 on parts list) to mount the solar
cell unit onto a solid surface. Make sure it is anchored into the solid
surface.
You can adjust the angle of the solar cell by moving the adjustment
support to the appropriate hook on the mounting bracket. Remem
-
ber, it must face as much DIRECT SUNLIGHT over the course of the
day as possible. Keep in mine shadows that may block sunlight at
some point during the day.
Now carefully route the solar cell power cord to the main unit and
plug it into the connector on the side of the unit.
FINAL ADJUSTMENT AND START-UP
After you successfully installed your SOLAR PIR SENSOR LIGHT, you
are almost ready for carefree operation with a few final steps:
Initial 3-days Charge:
On the main unit there is a dial switch with 2 positions:
●
OFF
●
AUTO
AUTO —
Position for normal operation of unit.
OFF ---
1) Position for shipping or extended periods of non-use
2) Position for initial 3-day charge before final adjustment and first
use. (Although the unit can charge, it is not operational in this
mode)
For now, turn the dial switch to OFF position. In this position the solar
cell will charge the battery without activating the unit. Leave the
switch in this position for 3 sunny days to ensure that the battery has
a full charge prior to motion sensor adjustment and normal opera
-
tion.
OFF AUTO
2