EN
9
EN
8
Installation
(Piping)
A
Drill a hole under Nano
You can fully hide the water pipe and
even the electrical cord. To do so, you’ll
need to drill a hole around 5 cm in
diameter.
1. Before drilling, check to make sure no
drawers or hardware will interfere and
that the pipe will reach.
2. Decide where you want to place your
Nano and mark the center. Drill a 5 cm
diameter hole.
B
Drill a hole behind Nano
Another solution is to drill a small hole near
the back of the counter to reach the under-
counter filter. In this case, you can hide the
pipe in a cable channel if you want.
1. Drill a hole in the countertop, at least
7 mm in diameter, to reach the filtration
system.
2. We suggest using angle fittings to direct
the pipe along the counter and through the
hole.
C
Go around
You can also install Nano without drilling
through the countertop.
1. Below the counter, drill a hole through
the shelf wall or bottom side. Feed the
pipe over the side and through the hole.
2. Use cable channel for fixing and hide
the water pipe.
From the under-counter filter, there are several ways to route the 1/4” flexible water pipe to your Nano. Here are three
possible solutions.
Installation
(Nano)
Connect Nano to the filtration system.
1
Lay the Nano down on a soft cloth to protect it while you
access the inlet water connector on the underside.
2
On the bottom, you will find a water inlet connector. There
are two options for leading and fixing the power cable and pipe,
based on your piping installation.
A
For Piping A
For A type piping, no need to use the pipe holder part.
B
For Piping B or C
For B or C type of piping, install the pipe holder part to the bot-
tom of Nano. This will fix the power cord and the water pipe in a
right place.
A
B
C
8