Hardware Diagram
:
Key
:
1. 2.4 G antenna
: For the RCAS control channel.
2. Audio input
: Connects to a waterproof
microphone with a 6-pin Lemo connector.
3. UHF antenna
: For RF signal transmission.
4. Serial number
: The unique number for RCAS ID
and control is on the back of the AquaMic.
5.
N/A
6. Status LED
: See manual for details on LED
patterns and colours.
7. Charge LED
: Red = charging, green = charged
and flashing red/green = error.
8. Charging port
: AquaMic charges through the
same connector as the audio input using the
charge dongle.
9. On/Off button
: There is no manual power
control button on the AquaMic to maintain the
waterproof seal.
10. Belt clip holes
: Allows vertical and horizontal
placement.
11. Switch:
Mutes and unmutes the transmitter.
Quick Start Guide Ref
M
ic HD
QT-5100R (RHD)
This Quick Start Guide is an overview. Users are asked
to review the entire manual for detailed instructions
Included Hardware
:
•
Carrying pouch.
•
RefMic HD transmitter (QT-5100RHD)
•
Micro USB charging cable
Users Also Need
:
•
Q5X Gateway (remote control)
• Handheld MicCommander (QG-H2) or
• Network Gateway (QG-N3)
•
Analog receiver
•
Microphone (1-pin Lemo connector)
Prepare the RefMic HD Transmitter
:
Bring the transmitter out of storage mode (minimal
battery draw) and into standby mode (detectable but the
UHF radio is off) using either method below:
•
Hold the ON/OFF button until the status LED changes
from flashing rapidly to slowly, or
•
Plug and unplug a powered micro USB charging cable
into the side of the transmitter.
•
Connect the 1-pin Lemo microphone
Prepare the Gateway remote control (H2 or N3)
:
•
Install the antenna on the top. (NEVER power the
unit without the antenna in place.)
•
Power the Gateway as instructed in its manuals.
•
Turn on the unit by pressing the power button.
Pair the RefMic HD and Gateway remote control
:
• The
screen on the Gateway displays the serial
number of paired transmitters.
• Press
the <MENU> button to either scan for
transmitters or add the serial number found on the
PlayerMic antenna.
Adjust
:
• Set
the functions in the two transmitter menus of the
Gateway. Screen one includes frequency, power On/
Off, battery level, mic mute/live and mic gain.
•
Screen two includes: transmitter name, group, RF
power, 2.4GHz channel, storage and reboot.
Battery Life
:
RefMic HD
8 hrs @ 50mW
Dimensions
:
66.5mm x 57.5mm x 20mm
10
8
10
10
1
3
11
9
7
6
4
10
2
User Tips:
When using the RefMic HD, it
is suggested that a strain relief
method be used to ensure that
there is no direct pulling force
on the microphone connector
during use or during removal.
One method is to loop the
microphone cable back and
tape the connector to the edge
of the transmitter.
