INSTALLATION
- QOM-eLED-PS+DALI-DT8
© 2021 Q-Tran Inc. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | [email protected] | www.q-tran.com
Specification subject to change. Rev-08-10-23
Swimming Pool Installation
Fundamental Construction
REGULATIONS
In accordance with the requirements of NEC680 regulation in the United States, when an illumination light is installed in the swimming pool, the distance from
the bottom of the terminal box to the ground shall be no less than 4 inches. The vertical distance to the water surface of the swimming shall not be less than
8 inches, and the horizontal distance to the water edge of the swimming pool shall not be less than 48 inches.
REQUIREMENT FOR POWER SUPPY
Please use only an isolating low voltage power supply with ungrounded output, evaluated for swimming pool use.
All the fundamental constructions, including the installation of junction box and switch, cable bushing and laying,
the digging of slots, etc., should be done before the light installation.
For swimming pool, the embedded installation is strongly suggested so as to secure the swimmers'
safety and avoid the damage to lights, so a slot for implanting profiles should be prepared on mounting
surface first, suggested slot sizes: 0.95” in width, 0.98” in depth.
0.98”
0.95”
Pool Spa Waterproof Junction Box
Corrosion
Resistant Conduit
8 in. Min. Bottom of
J-box to Top of Water Line
48 in. Min. J-Box
to Edge of Pool
Seal Conduit Entry with
Pool-grade Silicone Sealant
To Class 2 LED Driver,
GFCI, &Circuit Breaker
4 in. Min.