Q-tran FLEX Square, Installation Manual

Page: 16 / 27

© 2020 Q-Tran Inc. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | sales@q-tran.com | www.q-tran.com Specification subject to change.
Rev-03-08-21
INSTALLATION
FLEX Light - FLEX Square
NOTES:
• Field modifications must comply with Q-Tran’s installation methods otherwise warranty is null and void
Snap End Cap
3. Inserting the Feed Connector
4. Treatment of Anti-Skidding Clip
5. Installation of Anti-Skidding Clip
The following operations are prohibited:
Insert into the front side of the PCB Insert crosswise into the PCB Insert crosswise into the PCB
It will be a 0.08”-0.20” gap.
Unfold the anti-skidding clip about 20
degrees on both sides.
Place the anti-skidding clip onto the assembly end of the light.
Pay attention to its direction
Fit the anti-skidding clip to the end of so that it wraps tightly and
its brim is aligned with the cut edge on both sides.
W = 0.08”-0.20”
W
W=0.08”-0.20”
The following operations are prohibited:
Insert into the front side of the PCB Insert crosswise into the PCB Insert crosswise into the PCB
It will be a 0.08”-0.20” gap.
Unfold the anti-skidding clip about 20
degrees on both sides.
Place the anti-skidding clip onto the assembly end of the light.
Pay attention to its direction
Fit the anti-skidding clip to the end of so that it wraps tightly and
its brim is aligned with the cut edge on both sides.
W
W=0.08”-0.20”
The following operations are prohibited:
Insert into the front side of the PCB Insert crosswise into the PCB Insert crosswise into the PCB
It will be a 0.08”-0.20” gap.
Unfold the anti-skidding clip about 20
degrees on both sides.
Place the anti-skidding clip onto the assembly end of the light.
Pay attention to its direction
Fit the anti-skidding clip to the end of so that it wraps tightly and
its brim is aligned with the cut edge on both sides.
W
W=0.08”-0.20”
The following operations are prohibited:
Insert into the front side of the PCB Insert crosswise into the PCB Insert crosswise into the PCB
It will be a 0.08”-0.20” gap.
Unfold the anti-skidding clip about 20
degrees on both sides.
Place the anti-skidding clip onto the assembly end of the light.
Pay attention to its direction
Fit the anti-skidding clip to the end of so that it wraps tightly and
its brim is aligned with the cut edge on both sides.