© 2020 Q-Tran Inc. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | [email protected] | www.q-tran.com
Specification subject to change.
Rev-03-08-21
INSTALLATION
FLEX Light - FLEX Square
NOTES:
• Field modifications must comply with Q-Tran’s installation methods otherwise warranty is null and void
Cautions
Bending
Wrong Approaches
1. Before making any cuts, installation, maintenance or connection, be sure the main power is disconnected.
2. Note: all connector joints must be connected correctly to achieve IP68 rating.
3. Please operate this fixture by instructions, and confirm the work voltage, it must be matched with product requirements.
4. Please confirm the polarity of connector before insertion front connection cable.
5. Connect and cut this product correctly. Any wrong operation will damage this product.
6. Use qualified DC power supply.
7. Please correctly use and bend this fixture.
8. Do not operate light when ambient temperature exceeds the range of specified temperature.
9. Do not energize the light over 30 minutes in coil packaging.
10. Do not mix the four colors (R,G,B,W) in full load simultaneously.
Light Surface
WARNING: The above wrong approaches will damage the light.
Light Surface
Light Surface
Keep the min. bend diameter 11.81”
11.81”
(VB)Vertical Bending
Light Surface
Light Surface
WARNING: The above wrong approaches will damage the light.
Light Surface
Light Surface
Keep the min. bend diameter 11.81”
11.81”
(VB)Vertical Bending
Light Surface
Light Surface
WARNING: The above wrong approaches will damage the light.
Light Surface
Light Surface
Keep the min. bend diameter 11.81”
11.81”
(VB)Vertical Bending
Light Surface
