4
4.
Storage
4.1.
When you are finished using the heater you should make sure that the fire
is completely out. Allow at least 60 minutes for the heater to cool down before
moving.
4.2.
All unused wood pellets need to be moved out from the hoppers, feeding tunnels
and combustion chamber. Pellets collect moisture when exposed to the air making them
less flammable and will swell and stick to metal surfaces.
4.3 Store the heater upright in a sheltered area away from weather such as rain, snow and
dust.
4.4 This unit is manufactured as an “Outdoor Unit’’ from steel. If you leave it in the
weather it will accumulate rust. This is normal and can be treated by using high temp
spray paint not included with the heater.
5.
Maintenance
5.1 To obtain the best performance from your heater make sure you perform the
following maintenance procedures on a regular basis.
5.2 After a burn and once the heater is completely cooled, clean out any remaining ashes
from on top of the fire grate and in the ash pan. Do not dump an ash pan with hot embers
or pellets into a garbage can or any other combustible area. It will start a fire.
5.3 Keep exterior surfaces clean. Use warm soapy water for cleaning.
5.4 Never use flammable or corrosive cleaning agents on or near this stove.
5.5 Brush out dampers and clean out the spark arrestor to keep it unobstructed.
Caution:
Never burn stick wood or plastic or other combustibles in this stove. Burn only 1/4’’
(.006cm) diameter wood pellets. Never spray any cleaning product on or into any of the
doors, air intakes, or dampers.
6.
To Stop the Unit during a Firing.
To stop the flow of pellets, push in on the handles located on each side of the base. It
will take 15 to 30 minutes for the pellets left in the chutes and in the chamber to burn off.
SEE MORE STOVES AND FIREPLACE PRODUCTS, CHECK THE ELECTRONIC
VERSION OWNER’S MANUAL AND INSTALLATION VIDEO, PLEASE VISIT:
WWW.QSTOVES.COM
WEAR PROTECTIVE GLOVES WHEN ASSEMBLING.
CAUTION! PAINT IS EXTREMELY FRAGILE PRIOR TO CURING.
GENTLY UNWRAP ALL PARTS. DO NOT SET PAINTED PARTS ON ABRASIVE
SURFACES.
Patent Pending: QSTOVES INC.
Copyright 2016 All Rights Reserved
Version 5.11
