Q-Light S100D Operating Manual Download Page 2

 
 

 

  Signal Line : UL1007-NO.22(0.3sq) 400mm   

 

 

 

 

 

▪  This product was manufactured with the structure for indoor use.     

Installing in any direction is okay for indoor use. 

▪  Outdoor use is limited at a place where no water or very little 

water percolates. Mounting also should be done only with 

vertical standing shape. 

▪  Mount at the place where exists low vibration, low impact, low 

moisture and low dust as long as possible.   

▪  Refer to below information and drill necessary mounting holes on   

profitable part of the product. 

(Make sure PCD from external view drawing.) 

▪  F

ix the product by using nuts(M5-3EA) originally equipped on   

mounting bolt on bottom of the product.   

 

 

Refer to following drawing and explanation for right operating. 

 

S100D                                            S125D 

 

 

1) Lens Removal 

Remove lens① by turning it counterclockwise and make sure   

related parts on assembling board②. 

 

2) Bulb Change   

※  Warning ! Turn off Power 

Must turn off power supply and change the bulb after at least   

1 minute. 

▪  Make sure the rated voltage and wattage of new bulb. If the   

voltage of new bulb is higher than that of original bulb, the   

self-life  of  product  can  be  reduced  and  can  cause  damage  on 

lens  and  reflector.  Therefore,  please  use  same  bulb  as  original 

one which has same rated voltage and wattage or lower one.   

▪  Bulb Removal : Press slightly the bulb downward and turn it   

counterclockwise for removing.   

▪  Bulb Fitting : Fit new bulb into the socket by pressing it   

clockwise.   

 

Bulb Removing            Bulb Fitting 

 

 

3) Lens Assmebling 

Assemble the lens in reverse order of separating.

 

 

 

▪  If using voltage is seriously higher or lower than rated voltage, it   

can reduce the self-life of the product or can cause a problem   

on product operating. Make sure the using voltage does not   

/- 5% of the rated voltage. 

▪  If lens or body of the product is contaminated by chemicals such   

as thinner, benzene, the product can be damaged, discolored 

or deformed. Please be careful. 

Reviews: