The product has a power line, LAPP KABEL CLASSIC 400P 0.75sq X
2C 400mm, coming out from the product.
▪
In case of using DC voltage, the product has a bridge circuit inside,
therefore lines can be connected regardless of the polarity(Ref. wire
color).
▪
The structure of the product is manufactured for indoor use. Installation
in any direction is okay for indoor use.
▪
Mount at a place where exists low vibration, impact, moisture and dust
as long as possible.
▪
Refer to below information and drill the hole in a suitable part of the
product. (Make sure the PCD from the external view drawing.)
▪
QWSL150/QWSL250:
Fix the product by using extra mounting bolt
(M4-4EA).
QWSL150
QWSL250
▪
QWSL150-QBK03 / QWSL250-QBK03:
Fix the product by using the
attached mounting bolt(M6-3EA).
QWSL150-QBK03 / QWSL250-QBK03
▪
For left/right side angle adjustment, loose the fixing bolt
①
on the
bracket and adjust the angle. (Refer to the product structure drawing)
▪
For up/down side angle adjustment, loose the fixing bolt
②
on the
bracket and adjust the angle. (Refer to the product structure drawing)
▪
The product is designed for an explosion proof, water proof and dust
proof product.
When disassembling and assembling the product, please
make sure all the parts are well connected and check the bolts are
completely airtight.
▪
If voltage goes seriously higher or lower than the rated voltage, it can
cause the reduction of the life span of the product or cause an operating
problem. Make sure the voltage does not /-5% of the rated
voltage.
▪
Please keep the product from chemical substance such as thinner or
benzene. Lens or body of the product can be damaged, discolored or
deformed by chemicals.
Product Structure
Wiring Instruction
Mounting
Caution