8
3) Replacing the thermocouple
-
Remove control box cover on the kiln.
-
Remove locking wire.
-
Loosen connection screws and remove thermocouple.
-
When connecting the new thermocouple make sure that the
polarity is correct
:
PtRh-Pt element Type-S
NiCr-Ni element Type-K
red wire to (+) port
red wire to (+) port
white wire to (-) port
green wire to (-) port
-
Secure the new thermocouple with locking wire.
Warranty conditions
We provide a guarantee of 3 years from date of purchase on flawless manufacture and
function of every PYROTEC-kiln. Heating elements and thermocouple are parts subject to
wear and therefore not included in the guarantee. Additionally, the manufacturer is not liable
for damages resulting from improper handling of the kiln and ware.
ATTENTION: the fire bricks of the lining are exposed to strong temperature fluctuations
which can cause hairline cracks. This process is normal and does not compromise the
function of the kiln. Therefore, it is not a reason for complaint. For the register of warranty
claims please send us the information on the type plate and a copy of the bill from the dealer.
Faults and their likely causes:
Fault
Likely causes
Kiln does not heat up
kiln lid is not closed correctly
lid safety switch is out of adjustment
Contactor is defective
Thermocouple is defective (replace, see page 14)
Kiln does not or too slowly
reach final temperature
A heating element is defective (test, see page 13)
In kilns with three-phase power connection, a fuse has
blown in the meter box
Heating elements are failing due to old age (replace, see
page 13)
Kiln shuts down before
reaching final temperature
Short-term power failure
Controller is defective (contact your dealer)
Kiln shuts down immediately
Thermocouple is defective
compensating cable to the thermocouple is defective
When troubleshooting, please also consult the controller instructions.
Technical details are subject to change.
