Step 1:
Please find the correct software in the downloads tab of
your purchased device on www.pyroscience.com
Step 2:
Unzip the installer package and start "setup.exe". Follow the
instructions of the installer software. After successful installation
there will be a new program group "Pyro Oxygen Logger" in the start
menu and a shortcut "Oxygen Logger" on the desktop.
Step 3:
Connect the
Piccolo2
either directly or with the included
USB extension cable to a free USB port of the PC. Wait for "pop-ups"
in the lower right corner of the desktop indicating that the computer
has initialized the correct USB driver.
Step 4:
Slightly loosen the nut at the sensor port of the
Piccolo2
.
Remove the protective cap from the instrument end of the
robust/dipping probe or optical fiber/rod and insert it carefully into
the sensor port of the
Piccolo2
. Now fasten the nut with your fingers
at the sensor port of the
Piccolo2
.
•
Step 5:
Start the
Pyro Oxygen Logger
software, adjust the
Settings
and enter there the
Sensor Code
written on the label attached to the
sensor. Adjust the required logging parameters, perform a manual
Calibration
(1-
or
2-point calibration)
of the sensor at conditions
close to the environmental conditions during the measurements and
activate
Log to File
for data saving.
For the 0% calibration, it is possible to use
PyroScience
calibration
capsules (item no.
OXCAL
).
IMPORTANT
: This quick start does not replace the manual. The user
is strongly advised to download and to study the manual of the
Piccolo2
in order to avoid inappropriate use!
