Pyronix Ltd, Secure House, Braithwell Way, Hellaby, Rotherham, South Yorkshire, S66 8QY.
E: [email protected]. W: www.pyronix.com
The GSM module is used to communicate either via Contact ID, Fast Format or SMS. It will also enable
remote uploading/downloading via a PC to the control panel.
NOTE: The availability of these features is dependent on the network operator for the SIM card used in the
modem. Not all networks will support all the features. Also check periodically the credit of SIM card.
Antenna: The supplied antenna must be connected as shown above. The antenna then must be situated in a
position where the signal strength is high - this can be monitored via the LEDs.
Printed Circuit Board
12V DC Connection:
The power connection for the GSM Module.
Modem Data Connection:
Connection for data to the control panel.
SIM Card:
Must be present for the GSM to operate
Technical Specification:
Formats:
Fast Format, Contact ID, SMS , supports upload/downloading
Baud Rate:
9600bps
Voltage:
+12VDC
Quiescent:
40mA (In use: 420mA)
Dimensions:
110 x 56 x 10mm
Please see the control panel (that this is being connected to) user, programming and quick set up manuals for
further information. Minimum time for the detection of GSM fault signal = 2 minutes 30 seconds.
Connection to the PCX 46 (Export only) control panel
GSM Antenna
Information : The Digi-GSM can only be used on PCX 46 (Export only) and
Enforcer version 9 and above control panels.
For electrical products sold within the
European Community. At the end of the
electrical products useful life, it should not
be disposed of with household waste.
Please recycle where facilities exist. Check
with your Local Authority or retailer for
recycling advice in your country.
NOTE: When connecting the GSM, make
sure the control panels mains and battery
are powered down.
NOTE: When connecting a Digi GSM to the Enforcer control panel, please use the power connector
marked ‘GSM modem’ on the inside of the plastics.
Compliance:
Security Grade 2
Environmental Class II
EN 61000-6-3:2007
EN 50130-4: 2011
EN 60950-1:2006 +A12: 2011.
ETSI EN 301 511:V9.0.2
ETSI EN 301 489-1 V1.8.1/ -7 V1.3.1
EN 50136-1-1: 1998 + A2: 2008
EN 50136-2-1: 1998 + A1: 2001
ATE INPUTS