Pyreos ezPyro SMD, User Manual, Page: 7 / 18

ezPyro
TM
Flame Detection Evaluation Kit User Manual
Page 7 of 18 © Copyright Pyreos Ltd. 2020 ezPyro
TM
User Manual Rev. 3.1
If the program fails to make a connection to the data capture board, an error message is displayed, and the screen
returns to its initial screen. Check the USB connection and try to connect again.
When the TO version of the Flame Evaluation kit is connected the window changes to show three scopes and the status
bar now indicates that the TO firmware is running. See
Figure 7.
The SMD and TO GUIs both provide the same functionality and work in the same way.
Sample Frequency (Hz): This label shows the calculated frequency of incoming data. The calculation is based on the
system timer of the computer, so its accuracy and stability are dependent on the computer being used.
7.3 ezPyro
TM
sensor settings
The settings of the ezPyro
TM
sensors within the kit can be accessed by selecting the “Show Settings” item in the
“Options” menu, as shown in
Figure 8
. The settings can only be changed when the software is successfully connected to
the Evaluation Kit.
Figure 8: Finding the Evaluation Kit settings
Figure 7: ezPyro
TM
TO Flame Evaluation main window