www.PyleUSA.com
28
29
www.PyleUSA.com
5. SPEAKER SETUP
5.1 SPEAKER SETUP PAGE
DOWN MIX MODE:
Sets front
speakers to
LT/RT STEREO, V SURR
*
The first 3 settings (LT/RT, STEREO,
V SURR) downmix the sound Signal
for 2-Speakers. This setting allows
you to enjoy a surround sound-
effect with only two speakers. For
this reason a setup for additional
speakers (described in the following
sections) is disabled when
DOWN
MIX MODE
is set to these settings.
6. DIGITAL SETUP PAGE
6.1 OP MODE
OP MODE:
This can set the type of
output and adjust audio frequency
6.2 DYNAMIC RANGE
DYNAMIC RANGE:
When
LINE OUT
is selected, choose this setting to
adjust the line out ratio and get
different effect. If adjusting to FULL,
the audio signal peak value will be
the minimum; while adjusting to OFF,
maximum
6.3 DUAL MONO
DUAL MONO:
If your amplifier/de-
coder has Dolby Digital output, you
may select stereo, left mono, right
mono, or mixed mono mode for your
amplifier decoder.
7. SOURCE
SOURCE:
This system will automati-
cally read the USB if there is no
playable disc loaded. Use the Source
menu to select to read from either
disc and USB directory.
TROUBLESHOOTING
Before calling for service, you can perform the solution described in the
troubleshooting guide for immediate solutions.
PROBLEM
POSSIBLE REASON
TREATMENT
Unit can not be turned on
The power plug is not plugged
in properly or is damaged
Try plugging in again
Remote control
doesn't work
No battery or batteries are off
Replace batteries
The remote control used
is out of operational range
Use it with right range
No picture
Unit was not connected properly
Connect again
Unit was not set up properly
Check setup instructions
Disc cannot be played
Disc error
Label side should be up
loader doesn't
close
tray
Reload disc in tray
No disc in tray
Put disc in tray
No sound
Unit not connected properly
Connect
it
again
Volume too low
Adjust volume
Poor picture quality
and audio
Disc dirty
Clean the disc
Disc scratched
Replace Disc
Discwarpad
Display correctly but
no response
Operation is wrong
Renew operation
Without response
Main unit is jammed
Reset
