www.PyleUSA.com
7
Remote Control
1. Remote control should be operated within 6 meters with a scope of 30°
in front of the receiver.
2. Make sure that there is no large obstacle between the remote control and
the machine.
3. Remote sensor should be far away from the light, high amounts of light
can affect its performance.
SAFETY INSTRUCTIONS
1. Make sure that all connections are properly connected and the main
volume is set to minimum level before turning
ON
the unit.
2. When more than one pair of speakers are used, (specially the main
speaker output) make sure that the speakers used are of the same wattage
and impedance, otherwise the unit maybe damaged under high power or
long term operation.
3. To avoid humming sounds and unwanted noise,make sure that all the
wires are properly inserted
4. For speaker cords, strip off the vinyl coating and twist the wire tip.
Push down the pink jack or loosen the screw terminal, before inserting the
wire tip, then fasten it and tighten the screw. Be careful not to let the wires
stick out ofthe terminal otherwise this may cause a short circuit when
wires of different terminal contact each other.
5. After the unit is turned
ON
, adjust the main volume to the desired level
same with the bass and treble volume, etc.
Summary of Contents for PWMA1003BT
Page 10: ......
