www.PyleUSA.com
8
X-OVER FREQUENCY CONTROL
A.
When the crossover control is in the Low-Pass position, this control becomes
active allowing you to select your crossover point.
B.
When the crossover control is in the High-Pass position, this control becomes
active allowing you to select your crossover point.
CROSS OVER SWITCH
•
Full:
full range frequency.
•
Low pass:
the lower frequency under setting point can be pass.
•
High pass:
the higher frequency above setting point can be pass.
BASS BOOST CONTROLS
This amplifier has Bass controls for making good sound combination.
FUSE
The amplifier is equipped with a plug-in auto fuse protecting the set against
fault conditions. Do not use a fuse with a higher value and never bridge the fuse
over, as this may lead to irreparability damage so that any claim for warranty is
denied.
GND (-) = GROUND CONNECTION
Connect the GND terminal to the chassis ground of your car and take care of
best electric and mechanic contact. ln doing so, drill a hole in to the car chassis
near the amplifier then remove color, dirt, or any other substance from the
ground point. Thereafter fasten the cable end with added ring terminal by
using a screw. Ensure that the ground connection is as short as possible and
that the cable diameter is sufficient (min 4mm”). Route the ground cables from
the radio and all other equipment parts, like equalizer, active crossover network
or other amplifiers, to the same ground point.
+ 12V = POWER SUPPLY
Connect the BATT terminal to the positive pole of the battery with a lead cable
and add a fuse into the power cable in a distance of not more than 30 cm from
the battery. The lead cable's diameter should be at least 4 mm’ for a length of
3 m and 6mm" for a length of 6m.
