Connection
To ensure your safety, the driver should not watch videos or operate features on the monitor while driving. There are
no
serviceable parts in this unit, do not disassemble or try to repair this unit. If the unit malfunctions please return to
your
vendor or send to a Pyle repair facility. Please observe and obey the local laws and regulations when installing
the unit.
Upon Installation, please make sure as to not to interfere with any of the vehicle's safety features, wiring,
components, etc.
We are not responsible for any damages, injury, malfunctions or otherwise noted due to faulty or
non‐professional
Installation.
Please remember to disconnect your vehicle's battery prior to any connection / installation. Use the included wiring
harness
to
provide power and video signals to your monitor.
*
See the wiring diagram for connections between cameras, monitor and your
vehicle. When turning the vehicle's ignition key or turning to the accessory or ON position, power is supplied to the camera
system
-
-
if the system is properly connected and operational.
Please note: the 4‐Pin camera connection and camera system are compatible with other 4‐Pin video / camera systems.
Determine the best location for the camera to provide optimal viewing and driving assistance. Be sure when running the
connection cables to leave a small amount of slack so you can still move
or reposition
the camera if necessary
--
if you
decide to slightly adjust the camera's positioning at a later time.
*This kit includes necessary wiring and cable connector accessories sufficient for typical connections.
However, additional accessory cables and installation materials may be necessary for completely secure and
operational camera and driving assistance performance.
*Please remember to run cables in the least obtrusive route possible. Vehicle vibrations and bumpy driving
conditions can result, so extra care should be taken to securely mount the camera and fasten all cables and wiring
to secure locations.
*Ensure the wires are safely and securely connected, with proper isolation applied to all connections.
Front or Rear Vehicle Mounting Ability:
The driving camera system has the ability to be mounted the front or rear of your vehicle. The included 4
-
pin video
connection cable features an integrated looped wire that can be altered to adjust the camera's video picture output.
-
Cut the looped wire for
Rear
Vehicle Mounting
To display video
output as viewed by the camera lens
-
Leave the looped wire as is (connected) for
Front
Vehicle Mounting
To horizontally flip the video output
